The short answer
Check the Check Valve
The check valve sits on the discharge pipe above the pump. Its job is to keep water from flowing back into the pit after the pump shuts off. If it fails, water drains back, and the pump restarts within seconds, creating a rapid on-off cycle that feels like constant running.
You can test it by listening for a thud when the pump stops. If you hear water gurgling back, the valve is likely stuck open. Replacing a check valve is a straightforward job for a plumber or a water damage pro, but you can also ask a local pro to inspect it during a service visit.
- Listen for water trickling back after shutdown
- Check the valve flap for debris or wear
- Replace if it fails the simple backflow test
- Make sure it is installed in the correct direction
- Use a union fitting so the valve can be swapped easily
Look for a High Water Table
In wet seasons, the groundwater level around your home can rise above the sump pit bottom. That means water seeps in through the pit walls or floor faster than the pump can push it out. The pump then runs continuously, trying to keep up with the inflow.
If you live in an area with heavy clay soil or a high water table, this is a common cause. A water damage pro can measure the inflow rate and suggest a larger pump or a deeper pit. Sometimes a simple adjustment to the float switch height helps the pump cycle less often.
Inspect for Plumbing Leaks
A leak in your home's drain or sewer line can send water into the sump pit nonstop. Check for wet spots near the pit, a musty smell, or a constant trickle sound. A leaking pipe under the floor or in the wall can add gallons per hour without you noticing.
You can do a simple dye test by adding food coloring to a nearby toilet or sink and watching the pit. If the color appears, the leak is upstream. A plumber can locate and fix the source, or a leak detection service can use specialized tools to pinpoint the problem.
Examine the Float Switch
The float switch tells the pump when to turn on and off. If it sticks in the up position, the pump runs even when the pit is dry. If it hangs on the side of the pit or gets tangled, it may not drop down to stop the motor. This is a common issue after a power outage or if debris collects in the pit.
You can manually lift the float to see if the pump responds correctly. If the switch is worn or corroded, it needs replacement. A water damage pro can test the switch and adjust the tether length so the pump starts and stops at the right water levels.
When to Call a Pro
If you cannot find the cause, or if the pump runs for hours without stopping, turn it off to avoid overheating and call a local water damage pro. They can inspect the entire system, from the pit to the discharge line, and identify the exact issue. They may also check for water damage around the pit or in your basement.
In regions with cold winters and warm summers, sump pumps work hard during thaw and heavy rain. If you notice water stains or damp walls, a water damage inspection can reveal hidden issues before they worsen.
Policies vary, and your insurer decides what is covered. Keep your sump pump well maintained, and check the shutoff valve location so you can act quickly in an emergency.
Talk to someone now
Call (502) 305-4876 any time, day or night, and describe what happened.
Call Now (502) 305-4876Frequently asked questions
How often should a sump pump cycle?
A healthy sump pump should turn on and off a few times per hour during normal rainfall. If it runs constantly or cycles every few seconds, something is wrong. Check the check valve and float switch first, then look for leaks or a high water table.
Can a sump pump run nonstop and burn out?
Yes, continuous running can overheat the motor and shorten its life. If your pump runs for more than a few minutes without stopping, shut it off to prevent damage. Call a water damage pro to diagnose the cause before restarting it.
Why does my sump pump run after it rains?
After heavy rain, groundwater may stay high for days, so the pump runs more often. That is normal. If it runs constantly for more than a day, check for a stuck float or a check valve failure, which can make the pump cycle needlessly.